They are suitable for the transfer of liquids containing impurities up to 3 mm in size. The hydraulic components: impeller, scroll and pump body in PBT, allow it to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3 ° Engel). The liquid temperature must not exceed 70 ° C.
They are commonly used on:
They should normally be installed on a tank with a capacity proportionate to the flow rate, about 2-3 cm from the bottom. It is important to check that the maximum liquid level in the tank always remains 3-4 cm lower than the support flange (see figure).
In cases where the liquid is particularly dirty it is advisable to build the tank with compartments, to allow the deposit of sludge before it is fished out by the pump. For different uses it is advisable to consult our Technical Department.
|Power 1 (kW)||0,09|
|Power 2 (kW)||0,04|
|Depth Draft (mm)||80 120 150 180|
|Conn. Hydraulics (")||3/8|
|Maximum flow (l/min)||22|
|Maximum prevalence (mt)||2,5|
|Max impurity dim (mm)||3|
For further information about this product or if you want to know if it's right for your application contact us using the following form