SP 12

They are suitable for the transfer of liquids containing impurities up to 3 mm in size. The hydraulic components: impeller and nut in PBT, pump body in cast iron, allow it to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3 ° Engel). The liquid temperature must not exceed 70 ° C.

Applications

They are commonly used on:

  • machine tools (milling-lathes)
  • glass processing machines (TRI version)
  • surface treatment plants
  • filtration systems

They should normally be installed on a tank with a capacity proportionate to the flow rate, about 3-4 cm from the bottom. It is important to check that the maximum level of liquid in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is recommended to build the tank with compartments, to allow the deposit of sludge before it is fished out by the pump. For different uses it is advisable to consult our Technical Department.

Rating plate data

Attribute Value
Power 1 (kW) 0,15
Power 2 (kW) 0,07
Depth Draft (mm) 90 120 170 220 270 350
Conn. Hydraulics (") 3/4
Maximum flow (l/min) 65
Maximum prevalence (mt) 4,5
Max impurity dim (mm) 3
Impeller type Open

Materials

Material Material Option
Impeller PBT Cast iron
Pump body Cast iron
Impeller-cover PBT Cast iron
Shaft Steel Aisi 416

Download

Contact Us

For further information about this product or if you want to know if it's right for your application contact us using the following form